There exists a general consumer prejudice to the effect that in pre-fabricated and wooden buildings, application of insulation systems would be very difficult, required energy savings could not be achieved. As in the judgment ‘’If heat and sound insulation are made in reinforced concrete building structures, 100% success is ensured’’ these originate from lack of knowledge and misleading data and particulars are available as widely spread over the Internet media. Varying from heat insulation, the objective in sound insulation is minimizing sound trans-passage. If specific spaces such as single music chamber or cinema and concert halls are not considered, it is targeted to reduce sound transfer rather than eliminating. This approach is more realistic towards both reducing costs as well as enhancing the success rate.
Heat and sound insulation is of particular essence in prefabricated building structures. As is the case with construction materials, if in insulation materials, cost-efficient, reliable, easy and rapid to apply selections are made, comfortable spaces could possibly be presented to the customers. In prefabricated buildings where a wall thickness of 10 cm is technically required, first point to attend is heat insulation at the ceiling. As heated air rises, it should be avoided and prevented transfer of heated air outside through the ceiling gaps and spacing. As with all building structures, material selection should be compatible with the area you are living at. And for selecting the correct material you are required to work with a company specialized in its field. In prefabricated buildings, for heat, humidity and sound insulation, in recent years as an alternative to traditional insulation materials it is being used intensively polyurethane spray insulation foam. It is extremely easy to use such products which are rapid, practical and easy to apply. You are welcome to review ThermCoat Insulation Foam of superior quality, featuring adherence to all building construction materials and cost-efficient prices
In wooden buildings, unlike prefabricated building structures, it is preferred to start the entire insulation from the ground level. If earth connection is present at the ground level, heat insulator could be used. In case ground supports are used in the architecture of your wooden building, it would be correct to select a material referred to as wooden strips. At this point, it could also be included draft sheet for heat insulation. If the floor ground level of the building structure is earth-connected, a heat insulator is used. You should strictly select your materials from amongst new generation insulation materials. Thereby, you are able to get rid of and eliminate both air gaps/spacing as well as harmful effects moulds, fungi and bugs. At this point, by preferring single component Spray PU Foams, you are enabled to have access to all characteristics with just one single product. Materials used in the course of heat insulation process extending the life cycle of wooden buildings, shall also be reducing sound transfer to minimum.